ISO INTERNATIONAL STANDARD 1641-1 Third edition 2016-08-01 End mills and slot drills - Part 1: Milling cutters with cylindrical shanks Fraises cylindriques 2 tailles etfraises a rainurer- Partie 1:Fraisesaqueue cylindrique Referencenumber ISO 1641-1:2016(E) ISO @IS02016 International Organization for Standardization IS0 1641-1:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission.Permission canbe requested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 · CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Internationalbrganizatio for Standardization IS0 1641-1:2016(E) Contents Page Foreword .iv 1 Scope.. 1 2 Normativereferences. 3 Dimensions 1 4 Tolerances. Annex A (informative) Relationship between designations in this partofIS0 1641and IS0 133995 Bibliography.. ii International Organizations$b All rights reserved