ISO INTERNATIONAL STANDARD 16293-5 First edition 2016-12-01 Glass in building Basic soda lime silicate glass products - Part 5: Patterned glass Verredans la construction-Produitsdebase:verredesilicate sodo- calcique- Partie 5:Verre imprime Reference number ISO 16293-5:2016(E) ISO @ ISO 2016 Intermational Crganization for Standardization Provided by IHS under lic IS016293-5:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying,or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISo at the address below or ISo's member body in the country of the requester. ISO copyright office Ch.de Blandonnet 8. CP 401 CH:1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Provided by IHS under IS0 16293-5:2016(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normative references 3 Terms and definitions 4 Dimensionalrequirements .2 2 4.1 Thickness. 4.1.1 General. 4.1.2 Tolerances .3 .3 4.2 Length, widthand squareness 4.2.1 Stock sizes. .3 4.2.2 Final cut sizes. 4 5 Quality requirements .4 5.1 General. 4 5.2 Methods of observation and measurement .5 5.2.1 Visualfaults 5 5.2.2 Edgedefects for final cut sizes. 5 5.3 Acceptancelevels .6 5.3.1 Spotfaults .6 .1 5.3.2 Linear/extended faults 5.3.3 Patternfaults .7 5.3.4 Edge defects for final cut sizes 7 6 Designation Bibliography .9 ili Provided by IHS under license with ISO without license from IHS